Spark2 Control Not connected

Play your Spark 2 from any screen

This page holds one Bluetooth connection and one amp engine, and every view below runs on top of it. Connect once, then switch views as often as you like: the connection stays up and nothing is read again. The engine reads what the amp is playing when you connect and whenever you change presets on the amp, and it follows the amp's own knobs and switches as you turn them.

Classic and debug

The first hardware-style front-ends, and the console for raw frames.

Touch views

One design, one tone bar and the same gestures in all five.

Touch-view gestures

  • Tap a switch, tile or block for on / off (Grid: tap selects, double-tap switches).
  • Double-tap a pedal, or hold its screen, for every setting in a sheet.
  • Drag a knob up or right; hold still first for fine steps. Double-tap resets it.
  • Swipe a pedal's screen or a Grid block to change model.
  • Tone bar: ◀ ▶ step tones, tap the name for the list. Keys [ ] and 1–5.

Good to know

  • Needs Web Bluetooth: Chrome or Edge on desktop, or Chrome on Android, over https:// or localhost. On iPad or iPhone, install the free Beacio app (it adds Web Bluetooth to Safari), turn its extension on, and open this page in Safari.
  • The amp numbers its presets with one running index (1, 2, 3 …), not banks. Each switch on the amp is followed by a fresh read.
  • What the amp plays shows up as an “(amp)” tone. Stepping to one of your own tones sends its whole chain to the amp, switching models where needed.
  • The chain order is fixed in the amp, and EQ is a model in the modulation slot.
  • ·? marks a model whose knob order isn't confirmed yet. Values show 0–10; the amp takes 0–1.
  • Opening a view's file directly still works, but it then makes its own connection.